Tag: maple

The Milkman’s Workbench Build – The Ambidextrous Version – Part 6

Ok, let's finish this bench! With the screws completed and handles glued on all I have left to do is actually assemble the bench. I marked out the position of the screws on the end pieces and then drilled countersinks and clearance holes.

The glue-up starts at the end opposite the wagon vise. I glued the end piece on and then set it aside to dry. While that was drying I decided to make the 3/8" dowels that will reinforce the bridle joints. ​Making the dowels is a little easier than the large ones for the screws.

The Milkman’s Workbench Build – Part 4

Now that I have most of the bench complete it's time to start gluing and cleaning some things up. The first order of business was to glue up the two parts of the bench top. For this I used the same technique I used when I was gluing up the ash 2x4's for my bench top: apply the glue to both sides and then use parallel jaw clamps to keep the two pieces in alignment while you apply the clamping pressure. 

If you are gluing up more than two pieces this technique works great. After 15 minutes you can unclamp long enough to add another piece on and re-clamp the stack and keep going. You'll end up with a slab

The Milkman’s Workbench Build – Part 3

In my last post I had cut all the pieces for the bench to their final dimensions -  minus the end pieces which I intentionally left long. Today it's time to begin cutting some of the joinery for this little bench. The first task was to cut a groove in the front rail and back half of the bench top that will receive the tenons from the side of the wagon vise block.​

The grooves are 3/8" deep and 1/2" wide and must be centered in the stock. I decided to use my Whiteside 1/2" downcut spiral carbide router bit for these grooves. Normally I would do this operation on the table saw, but

The Milkman’s Workbench Build – Part 2

Today I started out by checking the squareness and moisture content of the roughly milled parts for the workbenches. None of them had moved that I could perceive. The moisture content had dropped about 1% since I brought the stock into the shop. At 9% I shouldn't have any issues with unexpected wood movement.  ​

I re-jointed all the parts and then started planing all the stock down to the specified 1 5/8". As I was preparing to rip the parts to width I noticed

Trestle Table Base is Almost Complete

I'm on vacation from work this week so I've been able to get quite a few hours of work in the shop. The base for this table is from a big maple tree my next door neighbor had cut down to put a pool in. I cut mortise and tenon joints for the leg-to-foot joint, which I will also draw-bore, and a notched bridle joint for leg-to-brace joint.